This bracelet seems very troublesome to make, but it surely’s not true! It’s truly only a ton of leap rings. You’ll need glue, 300 or so 10 mm brass leap rings, clasp, two brass barrel finish caps and cord. Start by utilizing a bit of glue so as to add your first finish cap. Let it dry for a hour. Start threading on leap rings, as in the event that they had been beads. Proceed stringing and pushing them collectively till you attain the tip. While you get to the tip, minimize your rope. Fill your finish cap with glue and press the tip of the rope into the cap. Press firmly for 30 seconds, after which enable to dry for an additional hour or so. Add a clasp to at least one aspect and a leap ring to the opposite one. Voila! Your new bracelet is completed!